N90S

18" Special staggered blade toe notching saw The Model N90 has been designed for a variety of heavy duty cutting applications, such as 45° double mitre cutting, notching of aluminum and plastic extrusions, or toe-notching of wood panels. This heavy duty machine can have blades set for notching or mitering. Blades move vertically on linear bearings on 1-1/4" (32mm) diameter hardened and ground rods. Keyed fences allow for each set-up and accurate dimensional changes. Specifications Vertical Frame and Notching Saw 3 H.P. 3 phase Magnetic Starter 2800 RPM Cutting Capacity Blade Capacity 16" OD (406mm); saw blades not included. 18" OD (457mm); optional Arbor 1" (25mm) with 3-1/2" (89mm) saw collars; mounted on preloaded and sealed bearings; 2-belt drive; 2800 RPM of spindle. Motors & Voltages Two, 3 H.P. 3 Phase 230/460 Volt Totally Enclosed Fan Cooled Motors, 60 Hz, 1725 RPM with Dual Magnetic Starter; 5 H.P. Motors available. Table Base Precision machined and ground iron castings with milled keyways to guide fences; allows for easy and accurate dimensional changes. Actuation Air operated by foot valve with cover. Air Pressure & Consumption 6 CFM at 100 PSI (.17 cubic meters/minute at 7.03 kg/cm2) based on 6 strokes per minute; includes air filter/ regulator/lubricator with auto drain. Size & Weight Standard Toe-Notch Machine 42" (107cm) Wide x 42" (107cm) front to back x 62" (157cm) High; Weight 900 lbs. (410kg). Production Rate Up to 10 strokes per minute. Cutting Capacity Staggered Saw Blades/ Toe-Notch Configuration; 6" (152mm) x 6" (152mm) Deep x 4" (102mm) High Mitre Cutting/Staggered Saw Blades; 4-1/8" (105mm) Wide x 4" (102mm) High Mitre Configuration/Non-Staggered Saw Blades; 4" (102mm) Wide x 4" (102mm) High; up to 6" (152mm) High with special blade guard modification at extra charge. Floor Stand Heavy gage steel; stand is completely enclosed with 6" (152mm) dust collector outlet and scrap chute; 1200 CFM required.